Hitachi Outdoor Unit, a Ten Minute Walk Around Check
Your Hitachi outdoor unit works hardest of any part of the system, yet most owners only notice it when something goes wrong.
A short walk around every month or two, with eyes and ears rather than tools, catches many problems early. This guide takes you around the unit in order, from the ground it sits on to the fan at the front, and flags what deserves a call.
Why bother walking around it?
Most outdoor faults start small. A drift of leaves against the coil, a shrub creeping closer, a cracked pipe cover or a loose bracket rarely stops the system on day one. Left alone, though, each can lead to overheating, high load stops, fan faults or leaks. Ten minutes of looking costs nothing.
What is safe and what is not?
Looking, listening and clearing debris from outside the cabinet are safe. Opening panels, touching wiring or reaching through the fan guard are not. Inverter boards hold stored charge after power is removed, and the fan can start without warning. Keep the covers on and leave the inside to a licensed technician.
Where should the walk around start?
Start at ground level. Check that the unit sits level and firm on its pad, feet or brackets. Look for cracked pads, sinking soil, rusty brackets or loose fixings. A tilted or wobbly unit vibrates more, wears its fan bearings faster and can strain pipe joints.
What should you look for around the Hitachi outdoor unit?
Next, check the space around it. The coil side needs open air, and the fan side needs room for hot air to escape. Bins, stored timber, pot plants, hedges and fences crowding the unit all cut airflow. Hitachi installation manuals specify clearances for each model, and more space is always better.
What about the coil itself?
The coil is the finned panel, usually at the back and one side. Look for leaves, seed pods, lint from a dryer vent, cobwebs and dust. With power off at the isolator, light debris can be brushed off gently or rinsed with low pressure water. Bent fins, heavy grime and salt crust need a technician.
How do you check the fan?
With the system running, watch the fan through the guard. It should turn smoothly. With power off at the switchboard and isolator, look for sticks or rubbish caught in the guard and remove anything reachable from outside without putting fingers through. Hitachi lists twelve flashes of the operation lamp for an outdoor fan motor fault.
Is wind a problem for some sites?
Yes. Hitachi lists a separate pattern, eleven flashes of the operation lamp, for the fan stopping due to strong wind. Units on exposed balconies, rooftops and hilltop homes can see gusts strong enough to stall the blade. If you notice that pattern on a windy day, a wind baffle or a more sheltered position may help.
Which sounds are normal?
A steady hum from the compressor, the whoosh of the fan, clicks as valves and relays change, and a soft hiss at start and stop are all normal. In winter, a louder whoosh followed by steam during defrost is expected.
Which sounds deserve a call?
Grinding, squealing, rattling, knocking and loud buzzing deserve attention. So does a compressor that tries to start, hums and stops. Our noise guide explains common outdoor sounds.
What about the pipes and cable?
Follow the insulated copper pipes and the cable from the unit to the wall. Look for torn or crumbling insulation, chewed sections and oily marks near joints, which can suggest a refrigerant leak. Damaged cable can cause communication patterns such as three or twelve flashes on the timer lamp.
Is water near the unit normal?
In winter heating, water and steam from the base during defrost are normal. In cooling, outdoor units usually stay fairly dry, and condensate drains from a separate hose connected to the indoor unit. Ice building on the outdoor unit in summer is not normal.
How does Sydney weather shape the checks?
Each season brings its own outdoor problems. For example, summer heat waves push the unit hard, so airflow and coil cleanliness matter most from December to February. Meanwhile, autumn leaf fall clogs coils in leafy suburbs. In winter, frost and defrost cycles are normal, but ice that never clears is not. Spring, by contrast, is the ideal time for a service before the heat returns.
Therefore, it makes sense to adjust your walk around to the season.
What should coastal owners look for?
Near the ocean or the bays, salt settles on fins, fixings and terminals. As a result, look for white crust on the coil, rust on brackets and screws, and pitted fins. Gently rinsing the coil with low pressure fresh water, with power off, helps remove salt. In addition, coastal units benefit from servicing twice a year, since corrosion can lead to leaks and electrical faults.
What should western owners look for?
In the hotter west, the main enemy is heat. Look at how much afternoon sun the unit receives and whether hot air can escape. Moreover, check that nothing has been stacked nearby since your last look. An open sided awning or shade sail that leaves plenty of airflow can lower the temperature the unit breathes. Our guide to operation lamp 16 flashes explains high load stops.
What about pests and wildlife?
Rats, possums, wasps, ants and birds all like the shelter around outdoor units. Consequently, look for droppings, nests, chewed insulation and ant trails into the electrical cover. Avoid disturbing wasp nests yourself. Pest damage to wiring can cause communication and sensor faults, so mention anything you find when you book.
How do you check after a storm?
After a storm, first walk around before switching the system back on. Look for fallen branches, dents, bent fins, a cracked fan blade or debris in the guard. Also check that the unit has not shifted on its base and that water has not pooled around it. If you see damage, leave the system off and call us.
Can you hose down the whole unit?
You can rinse the coil gently with a garden hose on a low setting, with power off at the isolator, spraying from the fan side outward where possible. However, never use a pressure washer, which flattens fins and forces water into electrics. In addition, avoid spraying into the electrical cover. Let the unit drip dry before restoring power.
Should you cover the unit when not in use?
No. Sydney does not need outdoor covers, and reverse cycle units need airflow in winter too. Covers trap moisture, encourage corrosion and invite pests. Leave the unit uncovered.
How does the outdoor unit affect running costs?
A clean coil, a healthy fan and open airflow let the system shed or gather heat easily, so the compressor works less. By contrast, a clogged or crowded unit makes the compressor run longer and harder for the same comfort. As a result, simple outdoor care often shows up as lower power bills.
How do balcony units differ?
On apartment balconies, outdoor units often sit against walls, under the balcony above or behind glass balustrades. As a result, hot air can pool around them on still afternoons, and wind can buffet them on exposed floors. Therefore, keep the area around the unit clear of bikes, boxes and plants, and never drape washing over it. If the unit regularly stops on windy days, ask us about wind protection.
What about units mounted on wall brackets?
Bracket mounted units save ground space but need secure fixings. During your walk around, look up and check for rust on the brackets, loose bolts or cracks in the wall around the fixings. In addition, listen for rattles when the unit runs, which can signal loose mounting. Never climb up to check. Instead, note what you see from the ground and let us know.
How does a unit on a narrow side path cope?
Side paths are common in Sydney, especially in newer estates, and outdoor units squeezed into them often face a fence only a short distance away. In that case, the hot air leaving the fan bounces back into the coil. Keeping the path clear and avoiding solid screens helps. If the unit trips often on hot days, relocation may be worth discussing.
Our installation page covers relocations.
What can a technician see that you cannot?
A technician can open the cabinet safely, check the outdoor board and its LED, test the fan motor and capacitors where fitted, measure refrigerant pressures, inspect terminals for heat damage and clean the coil through its full depth. Those checks go far beyond what an owner can safely do, which is why your walk around and a regular service work best together.
When is the best time to book a service?
Late winter or spring is ideal, before the first heat wave. Demand for technicians rises sharply once summer arrives, so booking early gives you a better choice of times. Homes near the coast or in very hot areas may benefit from a second service in autumn.
Should you keep a simple log?
A short note of each walk around, with the date and anything you noticed, helps you spot slow changes, such as a growing rattle or a spreading patch of rust. In addition, it gives the technician useful history when they visit.
What does the outdoor unit do differently in winter?
In heating, the outdoor coil becomes the cold side of the system, gathering warmth from outside air. Consequently, on cold, damp mornings frost forms on the fins, and the unit runs defrost cycles to clear it. During defrost, you may hear a whoosh, see steam and notice water dripping from the base. That is all normal. However, a thick block of ice that keeps growing points to a sensor or refrigerant problem.
Our guide to operation lamp 7 flashes covers outdoor sensor faults.
How do you know if the unit is running at all?
With the system set to cool or heat, stand beside the outdoor unit for a few minutes. You should hear the compressor hum and see the fan turn, apart from short pauses during start up, defrost or when the room has reached its setting. If it stays silent while the indoor unit blows air, check the isolator and breaker, then see our outdoor not running guide.
Can children play near the unit?
It is best to keep children away from outdoor units. The fan guard keeps fingers out of the blade, but sharp fins, hot surfaces and electrical covers are not toys. A small garden border or low barrier, placed well clear of the coil, can help keep play areas separate without blocking airflow.
Does a dirty outdoor unit affect the indoor lamps?
It can. A clogged coil or failing fan raises pressures and temperatures, which may lead the board to report load related patterns on the indoor operation lamp, such as five or sixteen flashes. Therefore, when those patterns appear, a quick walk around is the natural first step before calling us, and it often reveals an easy fix such as a pile of leaves or a stored item blocking the coil.
What should you do after the walk around?
Clear what you safely can, note anything unusual and book a service if you found damage, heavy grime, odd noises or signs of pests. Our service page explains what a technician checks.
Do we look after Hitachi outdoor units across Sydney?
Yes. Our technicians service and repair Hitachi outdoor units throughout Greater Sydney. Ring 02 9071 1142 or book through our contact page.
Frequently asked questions
How often should I check my Hitachi outdoor unit?
A quick look every month or two, and after storms.
Can I clean the coil myself?
Light debris yes, with power off. Bent fins and heavy grime need a technician.
What does eleven flashes mean?
Hitachi lists it as the outdoor fan stopping due to strong wind.
Is steam from the unit in winter normal?
Yes. It is usually defrost.
Should I open the cabinet?
No. Stored charge and moving parts make it unsafe.
How do I book a service?
Ring 02 9071 1142 or use our contact page.