Hitachi Operation Lamp Blinking 12 Times, Outdoor Fan Motor Fault

When the Hitachi operation lamp blinking 12 times shows up, the big fan in your outdoor unit is not doing its job.

That fan pulls air through the outdoor coil, and without it the system cannot shed heat in summer or gather it in winter. Hitachi lists the pattern as an outdoor fan motor fault. Debris, worn bearings, water damage and drive faults are the usual reasons.

What does twelve flashes mean?

The Hitachi airHome service catalogue lists twelve flashes of the operation lamp as a fan motor fault on the outdoor side. The outdoor board drives a DC fan motor and monitors its speed. When the fan does not turn, turns too slowly or behaves erratically, the board stops the system.

A separate pattern, eleven flashes, covers the fan stopping because of strong wind, which is a different situation.

Why is the outdoor fan so important?

In cooling, the outdoor coil releases the heat removed from your home. The fan pushes outdoor air through the coil to carry that heat away. In heating, the fan pulls air through the coil so it can gather warmth. Without the fan, pressures and temperatures spike within minutes.

How do you confirm the count?

Count the operation lamp flashes on the indoor unit between pauses, over two cycles. During heating, a slow regular blink while preheating or defrosting is normal and different. Long press a handset arrow key to start the service buzzer if needed.

What causes the Hitachi operation lamp blinking 12 times?

Common causes include the following.

  1. Sticks, leaves or rubbish jammed in the fan.
  2. Worn or seized motor bearings.
  3. Water or corrosion at the motor connector.
  4. Damage to the motor windings or electronics.
  5. A cracked or loose fan blade.
  6. A fault in the board circuit that drives the fan.

How does debris stop the fan?

Outdoor units sit near gardens, trees and fences. Sticks, seed pods, plastic bags and even toys can fall through or against the fan guard and jam the blade. A jammed blade stalls the motor, and the board reports the fault. Leaf litter packed around the unit can also rub on the blade.

How do bearings fail?

Outdoor fan motors spin for thousands of hours in heat, cold and damp. Bearings dry out and wear, first causing a squeal or grinding noise, then dragging the motor and finally seizing. A fan that turns slowly or stiffly by hand, with the power off, suggests bearing wear.

Can strong wind be confused with this fault?

Hitachi lists a separate pattern, eleven flashes, for the fan stopping due to strong wind. On exposed balconies and hilltops, gusts can push against the blade hard enough to stop it or spin it backwards. If you see eleven flashes on a windy day, the motor may be fine. Twelve flashes points to a genuine fan motor fault.

What can you safely check?

With power off at the switchboard and isolator, look through the fan guard for debris. Remove loose leaves from around the outside of the unit, but do not reach through the guard. Note any squealing or grinding you heard before the fault. Leave the cabinet closed.

Our outdoor unit guide explains safe checks.

Should you restart it?

Once you have cleared any debris from around the unit, one restart is reasonable. Switch off at the switchboard for at least five minutes, then restart. If twelve flashes return, leave it off. Running the compressor without the fan risks overheating. Our reset guide has the steps.

How do we diagnose the fan?

The technician isolates power, removes the guard or panels as needed, clears debris, turns the blade by hand to feel for drag, inspects the blade for cracks, checks the motor connector for moisture and corrosion, measures the motor supply and feedback, and tests the board drive circuit.

What repairs are typical?

For a jammed fan, clearing debris and refitting the blade usually solves it. For worn bearings or failed windings, the technician fits a new fan motor. Similarly, they replace a cracked blade and clean or renew a corroded connector. Finally, a failed drive circuit means a new outdoor board.

What does it cost?

Clearing debris is a quick job. A new fan motor costs more, and an outdoor board more again. Our pricing page explains the factors, and we quote before starting.

Which patterns relate?

Ten flashes of the indoor timer lamp relates to the indoor fan motor. Five and sixteen flashes of the operation lamp relate to heavy load, which a weak fan can cause. Our code list explains each.

How quickly does a stopped fan cause damage?

Very quickly. In cooling, refrigerant pressure in the outdoor coil can climb sharply within a minute or two once airflow stops. Consequently, the board relies on detecting the fan fault promptly and stopping the compressor. Running the system repeatedly in this state risks high pressure trips, overheating and extra wear on the compressor. Therefore, leave the system off once the pattern returns.

Why do fans often fail in summer?

Outdoor fans run for long hours in summer, often at high speed, while sitting in hot air. Moreover, the motor itself runs hotter, which speeds up bearing wear. As a result, motors that were close to the end of their life often fail during the first long hot spell. A pre summer service can catch noisy bearings before they seize.

Can water damage the fan motor?

Yes. Outdoor fan motors are designed to cope with weather, but water can still reach the connector or wiring through damaged insulation, a cracked housing or a unit sitting in a puddle. Over time, corrosion builds and the motor or its signal fails. Units at ground level in poorly drained areas are more exposed, so raising the unit on proper feet or a pad helps.

Do pests cause fan problems?

They can. Wasps sometimes build nests inside the fan housing, and rats or possums may chew wiring. Spiders and ants like the sheltered electrical compartment. In addition, birds occasionally nest on top of units near eaves. If you see signs of nests, mention them when you book, and avoid disturbing wasp nests yourself.

Does a slow fan cause other patterns?

Yes. A fan that runs but turns slowly may not trigger twelve flashes straight away. Instead, it may lead to heavy load patterns such as five or sixteen flashes on hot days, because heat cannot escape. Therefore, the technician checks fan speed whenever load related patterns appear.

What about balcony and rooftop units?

Units on balconies and rooftops often face stronger wind, more sun and more debris blown in from neighbouring areas. In addition, access may be harder. Hitachi includes a separate wind related pattern for exactly this reason. Our technicians plan access and safety carefully for elevated units.

How long does a fan repair take?

Clearing debris takes minutes. Fitting a new fan motor usually takes an hour or two once the part is on site. Since outdoor fan motors are model specific, the technician may confirm the fault first, then order and fit the motor on a return visit.

How can you prevent fan faults?

Keep the area around the outdoor unit clear of leaves, sticks and stored items, and trim plants away from the fan guard. In addition, book a yearly service so the technician can listen for bearing noise, check the blade and clean the coil. Also make sure the unit sits level on solid feet, which reduces vibration and bearing wear.

Is a new motor covered by warranty?

Hitachi lists a six year parts and labour warranty on its airHome wall mounted range in Australia. A motor that fails through a manufacturing defect may be covered. By contrast, damage from debris, pests, storms or poor placement may be treated differently.

What should you tell us when booking?

Tell us the indoor model number, whether the fan was turning before the fault, any noises you heard, whether debris was caught in the guard and where the outdoor unit sits. In addition, a photo of the outdoor unit helps the technician prepare.

How does the board know the fan has failed?

The outdoor DC fan motor reports its speed back to the board through a feedback signal, much like the indoor fan. The board compares the actual speed with the speed it asked for. If the motor stalls, turns far too slowly or the feedback disappears, the board knows something is wrong and stops the system. That feedback is why the fault appears so quickly when a fan jams.

Can the fan stop briefly as part of normal operation?

Yes. During winter defrost, the outdoor fan often stops while the outdoor coil warms to melt frost. In addition, on mild days in cooling, the fan may run slowly or pause as the board manages pressures. These stops are normal and do not trigger twelve flashes. Only when the board detects a genuine motor problem does the pattern appear.

What does a cracked blade sound like?

A cracked or warped blade often causes a rhythmic ticking, scraping or whooshing that rises with fan speed. The unit may also vibrate more than usual. If you hear these sounds, switch the system off and book a check before the blade breaks completely and damages the coil or guard.

Our noise guide describes common outdoor sounds.

Why should you never reach through the guard?

The fan can start without warning when power returns or when the board decides to run it. In addition, the blade edges can be sharp. Even with the system off at the handset, the outdoor board may still have power. Therefore, always switch off at the switchboard and isolator before looking closely, and never put hands or tools through the guard.

Does a new motor fix everything?

Usually, if the motor was the cause. However, if a seized motor stressed the board drive circuit, the board may also need attention. The technician tests the drive circuit as part of the job, so the new motor is not damaged by a faulty board.

How do we confirm the repair?

After the repair, the technician runs the system and checks fan speed across its range, listens for noise, checks vibration and confirms outdoor coil temperatures and pressures look normal. They also confirm no pattern returns during a test run.

Can a multi split show twelve flashes?

Yes. A multi split relies on one outdoor fan for every indoor head, so a fan fault stops cooling and heating throughout the home. Each head will usually show the outdoor pattern. Because multi split outdoor units are often larger, their fan motors can cost more, so prompt diagnosis is worthwhile.

Is it worth fixing an older unit?

Usually. An outdoor fan motor is a moderately priced part, and replacing it often restores years of service. However, if the outdoor coil is badly corroded or the compressor is also failing, replacement of the whole system may make more sense. Our technician explains both options so you can choose.

What can you do while waiting?

Keep the system off at the switchboard, since running without the outdoor fan risks overheating. In summer, close blinds, use fans and stay in the coolest rooms. In winter, use safe portable heating. Keep children and pets away from the outdoor unit until it has been checked.

When should you call?

Call if twelve flashes return after clearing debris and one restart, the outdoor unit squeals or grinds, or the fan blade looks damaged.

Where do we work?

We repair Hitachi outdoor fans across Greater Sydney. Ring 02 9071 1142 or book through our contact page.

Frequently asked questions

What does twelve flashes of the Hitachi operation lamp mean?

Hitachi service tables list an outdoor fan motor fault.

Can leaves stop the fan?

Yes. Debris can jam the blade and stall the motor.

What does eleven flashes mean?

Hitachi lists eleven flashes as the fan stopping due to strong wind.

Is it safe to run without the fan?

No. The compressor can overheat quickly.

Can I clear debris myself?

From outside the guard with power off, yes. Never reach through the guard.

How do I book?

Ring 02 9071 1142 or use our contact page.

{“@context”:”https://schema.org”,”@type”:”HVACBusiness”,”@id”:”https://hitachi.sydneyaircare.com.au/#business”,”name”:”Sydney Air Care, Hitachi Service”,”url”:”https://hitachi.sydneyaircare.com.au/”,”description”:”Hitachi air conditioner repair, service and troubleshooting across Sydney. Independent service provider, not affiliated with Hitachi.”,”areaServed”:[{“@type”:”City”,”name”:”Sydney”},{“@type”:”State”,”name”:”New South Wales”}],”parentOrganization”:{“@type”:”Organization”,”name”:”Sydney Air Care”,”url”:”https://sydneyaircare.com.au/”},”telephone”:”+61 2 9071 1142″} {“@context”:”https://schema.org”,”@type”:”FAQPage”,”mainEntity”:[{“@type”:”Question”,”name”:”What does twelve flashes of the Hitachi operation lamp mean?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Hitachi service tables list an outdoor fan motor fault.”}},{“@type”:”Question”,”name”:”Can leaves stop the fan?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Yes. Debris can jam the blade and stall the motor.”}},{“@type”:”Question”,”name”:”What does eleven flashes mean?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Hitachi lists eleven flashes as the fan stopping due to strong wind.”}},{“@type”:”Question”,”name”:”Is it safe to run without the fan?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”No. The compressor can overheat quickly.”}},{“@type”:”Question”,”name”:”Can I clear debris myself?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”From outside the guard with power off, yes. Never reach through the guard.”}},{“@type”:”Question”,”name”:”How do I book?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Ring 02 9071 1142 or use our contact page.”}}]}
Call 02 9071 1142